Separating the Cutting Unit from the Traction Unit (continued)
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
g207107
1.
Cutting unit pitch arm
6. Loosen the 2 flange-head screws that secure cutting unit pitch arms to the
traction unit roll frame. It is not necessary to completely remove the screws
(Figure
154).
7. Rotate the pitch arms forward and rest traction unit against the kickstand.
8. Roll the cutting unit away from the machine.
9. Reverse the procedure to install the cutting unit to the traction unit.
10. After the cutting unit is installed to the traction unit, connect the battery pack;
refer to
Connecting the Lithium Battery Pack (page
Figure 154
2.
Flange-head screw
Page 7–5
3.
Traction unit roll frame
7–3).
Cutting Unit: General Information