Toro Greensmaster eFlex 1800 Service Manual page 39

EZ Turn System is Not Working (continued)
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
Possible Causes
The EZ turn sensor on the cutting unit roll
frame is not adjusted correctly or is damaged.
The cutting unit pitch arms are binding on the
side plate bushings.
Machine Operates But InfoCenter Display is Not Working
Possible Causes
The wire harness connections or wires to the
InfoCenter display are loose or damaged.
The InfoCenter display is damaged.
Use the InfoCenter Diagnostics screen to
check the EZ turn sensor operation. Adjust or
replace the EZ turn sensor if necessary; refer
to the Operator's Manual for EZ turn sensor
adjustment.
Clean the pitch arms and bushings.
Check the electrical connections. Repair the
wiring as necessary.
Replace the InfoCenter display.
Page 3–5
Correction
Correction
Troubleshooting: