Backlapping (continued)
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
g207288
1.
Cover plug
5. Remove the plug from the reel drive cover on the left side of the reel
assembly
(Figure
157).
6. Insert a 1/2 inch socket onto the hex of reel driveshaft.
7. Backlap according to procedure in Toro General Service Training Book, Reel
Mower Basics (Toro Part No. 09168SL).
g207289
1.
Top angle
2.
Top surface
3.
Remove burr
8. When the backlapping operation is completed and the cutting unit is stopped,
run a file across the front face of the bedknife
any burrs or rough edges that may have built up on the cutting edge.
9. Install the reel drive cover plug when backlapping operation is completed
(Figure
157).
When adjusting the bedknife to cutting unit, ensure that the contact
is as light as possible to lengthen the amount of work the machine
will perform on each charge.
10. Adjust the cutting unit reel to bedknife as necessary.
11. If cutting unit is attached to the traction unit, slide the telescoping coupler
onto the cutting unit hex shaft. Connect the battery pack; refer to
the Lithium Battery Pack (page
Figure 157
Figure 158
4.
Front surface
5.
Front angle
IMPORTANT
7–3).
Page 7–9
(Figure
158). This will remove
Connecting
Cutting Unit: Service and Repairs