Toro Greensmaster eFlex 1800 Service Manual page 151

Testing the Parking Brake Latch Switch (continued)
Removing and Installing the Parking Brake Latch Switch
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
8. Replace the parking brake latch switch if necessary.
1. Disconnect the parking brake latch switch from the machine wire harness.
2. Remove the 2 washer-head screws and 2 locknuts that mount the switch to
the switch panel on the handle
the machine.
Note: For proper operation of parking brake latch switch, the screws and
locknuts used to secure the switch are stainless steel. If these fasteners are
replaced, ensure to use correct fasteners.
3. Position the switch to the switch panel and secure with the 2 washer-head
screws and 2 locknuts
4. Adjust the parking brake latch switch; refer to
(page 5–33).
5. Connect the switch to the machine wire harness. Secure the console cover
to the handle.
6. Connect the battery pack; refer to
(page 5–7).
(Figure 100), and remove the switch from
(Figure 100).
Connecting the Lithium Battery Pack
Page 5–51 Electrical System: Testing the Electrical Components
Parking Brake Latch Switch