Toro Greensmaster eFlex 1800 Service Manual page 237

Assembling the Roller
Greensmaster ® eFlex 1800, 2100 and 2120
12189SL Rev E
g206890
1. Roller
2. Ball bearing
1. Place the roller shaft (item 6 in
Note: If the bearing locknuts (item 5 in
the original locknuts for assembly purposes, if possible. This will preserve
the patch lock feature in the new locknuts. Use the new nuts only after new
bearings and seals have been installed.
Note: Special tool TOR4105 (refer to
can be used instead of washers and spacer when installing the bearings
and seals in roller.
g206891
1. Bearing
2. Position a new bearing, black assembly washer (refer to
Tools (page 2–18)) and original locknut onto each end of the roller shaft
(Figure 172).
3. Tighten the nuts until the bearings are seated into each end of the roller.
4. Remove the bearing locknut and black assembly washer from each end
of the roller.
Failure to grease bearing locknut before seal installation may result
in seal damage.
Figure 171
3. Seal
4. V-ring
Figure 171) into the roller.
Figure
Roller Rebuilding Tools (page
Figure 172
2. Black assembly washer
IMPORTANT
Page 7–23
5. Bearing locknut
6. Roller shaft
171) are being replaced, use
2–18))
3. Bearing locknut
Roller Rebuilding
Cutting Unit: Service and Repairs