Routing Of Wiring Harness For The Backrest Adjustment; Tools - Porsche 996 TT Repair Manual

1 Electrical plug
connection −5−
2 Backrest motor −4− Insert backrest motor −4− from below −direction of arrow− .
3 Input shaft −2−
4 Fastening backrest
motor −4−
5 Installing clamping
washer
Installing covering
for backrest
Installing front seat => Removing front seat
top of page

Routing of wiring harness for the backrest adjustment

1. −A− Plug on the control module for the memory seat adjustment.
2. −B− Plug on the backrest adjustment
motor.
3. −X− Plug connection − without control module for the memory seat adjustment.
top of page

Tools

Item Designation
1 Multimeter
top of page
Routing of wiring harness for the backrest adjustment
Push plug −5− on to electric motor until it engages.
Insert input shaft from the right side as far as it will go −arrow− .
Screw in fastening screw −3− . Ensure that the bushings −arrow− are seated
correctly. Counter electric motor with your hand and tighten fastening screw
−3− .
Tightening torque: 6 Nm (4 ftlb.)
Counter input shaft −2− on the right side and push clamping washer on to the
left side of the input shaft −2− using a 12 mm socket for example.
Special tool
einordnung
Explanation:
Gr. 2.5; Workshop Equipment Manual
1685