Removing display and operator control unit (PCM)
1. Unclip the −switch covers− from below and let them dangle from the electric leads.
2. Press together both spring clamps on the display and operator control unit and carefully pull
out.
3. Disconnect electrical plug connections from the display and operator control unit.
top of page
Installing display and operator control unit (PCM)
Note
•
After installation of a new display and operator control unit, the system must be activated with the
Porsche System Tester 2!
1. Engage the electrical plug connections and carefully lay the electrical leads (do not pinch).
2. Connect and switch on the Porsche System Tester 2.
Connecting and switching on the Porsche System Tester 2
1. Switch ignition on.
2. Switch on PCM by pressing the volume control (display remains
dark).
Removing display and operator control unit (PCM)
einordnung
1712