Removing And Installing Reflector Cover; Removing And Installing Wiring Harness - Porsche 996 TT Repair Manual

Removing and installing reflector cover

Removing reflector cover
Unscrew fastening screw −27− from the reflector cover −28− .
Install reflector cover
Secure the reflector cover −28− with the fastening screws −27− . => Tightening torques
=> Test and adjustment values
top of page

Removing and installing wiring harness

Removing wiring harness
1 Press the lug of the electrical plug connection, see inset −arrow− and separate.
2 Remove additional brake light. See: => Removing and installing additional brake light.
3 Pull out grommet −A− with brake light lead. Disconnect plug connection −B− for fan on fan housing.
Disconnect plug connection for engine compartment lighting −C− . Press the fastening clips −arrows−
together from the inner side of the mount and and remove.
Installing wiring harness
1 Lay the wiring harness and mount with the fastening clips from the inner side of the mount in the positions
specified −arrows− . Connect the plug −C− for the engine compartment lighting and −B− for the engine
compartment fan. Push the plug with the grommet −A− through the opening in the rear lid until the
grommet can be pushed into place.
2 Plug in the electrical plug connection.
3 Install additional brake light. See: => Removing and installing additional brake light.
Removing and installing reflector cover
einordnung
2024