EMERGENCY STOP switch − without centre console M 581 − in front of shift lever.
1. Carefully unclip the standard cover trims upwards with a suitable tool (e.g. screwdriver; plastic spatula).
2. The 3−pin plug connection required for the EMERGENCY STOP switch is located under the
cover in front of the shift lever and is marked with a white identification tape −A− . Connect the
3−pin plug to the plug connection of the EMERGENCY STOP switch and clip the relevant cover
back into place.
top of page
Removing the main battery relay
Note
•
After the removal of the main battery relay and switching off using the inner/outer EMERGENCY
STOP switch, the Work instructions after disconnecting the battery ' 9−1 General described in
Chapter 9 must be observed.
1. Remove the battery cover and the right cowl panel cover ' 702219 Removing and installing cowl panel
cover.
2. Disconnect the ground terminal of the battery and lower away frfom the battery terminal.
3. Disconnect the 6−pin plug connection on the main battery relay by pressing on the locking lever and
Removing the main battery relay
einordnung
2001