Porsche 996 TT Repair Manual page 1929

2 Shaft seal 1
3 Shaft seal 1
4 Ball sleeve 4
5 Outer bearing 1
race
6 Outer bearing 1
race
7 Outer bearing 1
race
8 Circlip 1
9 Selector lever 1
10 Rubber washer 1
11 Selector lever 1
12 Shaft seal 1
13 Bushing 2
14 Shift pinion 1
15 Adjusting shim X
16 Snap ring 1
17 Closure cap 1
18 Compression 1
spring
19 Bearing screw* 1
20 Swivel arm 1
Overview
einordnung
Remove with special tool striker
VW 771 , special tool threaded
part VW 771/15 and a suitable
internal puller.
Drive out with aluminium or
copper mandrel, changing sides.
Drive out from the inside with
special tool pressure piece VW
513 .
Drive out from the inside with
special tool drift P 264 b .
Drive out with special tool
pressure piece 9648/2 .
Mark for refitting.
Remove with special tool socket
wrench insert 9658 .
• Unscrew it only if the
transmission has to be
disassembled!
Install only after fitting the gear set.
Drive in shaft seal with pressure piece
VW 513 as far as the mounting face. Fill
the space between the dust and sealing
lips with grease (e.g. Liqui Moly).
Drive in with special tool pressure piece
9648 . (Installation depth 0.6 mm).
Drive in with special tool pressure piece
3062 and special tool mandrel VW 295
as far as the mounting face.
Drive in with special tool pressure pieces
9247 and special tool pull−in tool and
extractor P 254 .
Drive in with special tool pressure piece
P 254 b and special tool pull−in tool and
extractor P 254 .
Fit in correct position and make sure it is
seated properly.
Use special tool protective sleeve 9649 .
Insert in the correct position.
Drive in with special tool pressure piece
9649/1 . Fill the space between the dust
and sealing lips with grease (e.g. Liqui
Moly).
Drive in with special tool pressure piece
9648/1 .
Axial play 0 to 0.15 mm. Setting with
shim (No.15).
Remeasure if necessary.
Push the snap ring and cap (no. 17)
down until the snap ring engages into the
groove.
Tighten to 50 Nm (37 ftlb.).
1866