Install fan with
fan housing −10−
6
Install upper part
of lock −8−
7
Install adjusting
element
8
Install rubber
cover −4−
9
Install additional
brake light −3−
Installing rear
spoiler
Replace model logo
1. Position logo with the dimensions −X = 360 mm− and −Y = 20 mm− on the rear lid and affix.
Removing and installing rear−lid wiring harness
Replace model logo
Position the fan housing and fan −10− on the mount. Tighten with the fastening
screws −9− . Connect plug connections for fan and engine compartment
lighting on the fan housing.
Position upper part of lock −7− and fasten with fastening screws −8− .
Engage collar −6− . Screw in rubber pads −5− . Apply plasticine to the rubber
pad, close and open the lid. Determine the thickness of the plasticine and screw
the rubber pad in or out accordingly. => Diagram − body gap dimensions
Press the rubber cover −4− into the rear lid −1− .
Push on electrical plug −C− . Insert the brake light into the rear lid. Lock the
lock −B− . Engage cover −A− .
' 665819 Removing and installing rear spoiler − GT2
einordnung
1966