Inserting Rear Closing Panel - Porsche 996 TT Repair Manual

• All straightening work on the body in this area must have been completed before the damaged parts
are removed.
No. Procedure
Placing vehicle on the
alignment bench
1 Separating the spot−welded
joint at the rear closing panel.
2 Separating the spot−welded
joint at the rear closing panel.
3 Separating the spot−welded
joint on the engine mount at
top
4 Separating the spot−welded
joint on the engine mount at
bottom
top of page

Inserting rear closing panel

Inserting rear closing panel
einordnung
Instructions
Place the vehicle with the units mounted at the front onto the set of
straightening attachments and fasten it in position.
Use a spotweld cutter to separate the connection between the inner
side members and the rear closing panel −A− on the left and right.
Use the spotweld cutter to separate the connection between the side
section on the inside and the rear closing panel −B, C− .
Separate the spot−welded joint between the engine mount at top
−D− and the inner side member and the connection to the inner
side section −F− with the spot−weld cutter.
Use the spotweld cutter to separate the spot−welded joint between
the engine mount at bottom −E− and the inner side member.
2008