Installing the car radio
1. Before the new radio is installed, unlock and disconnect the protective plug −A− for the optical
waveguide.
2. Press in electrical plug and optical waveguide plug on car radio until the plugs are felt to engage −a− .
Note
•
Before sliding the car radio into the installation slot, make sure that the electrical leads are not trapped
by the car radio or damaged.
3. Push the car radio into the installation slot until the locks engage on the radio
housing.
top of page
Teaching the car radio
Note
•
If a new car radio is to be installed in a vehicle, the PCM2/CDR23 code specified in IPAS must be
used.
•
You can get the codes from IPAS or from your importer by specifying the vehicle identification
number.
If possible, before the car radio is removed and replaced, a read−out of the vehicle data should be
•
obtained and noted down using the Porsche System Tester.
•
During coding, the power supply for the Porsche System Tester should be guaranteed. Connect a
battery charging device to the vehicle battery.
Installing the car radio
einordnung
1735