Porsche 996 TT Repair Manual page 2098

a. Insert coolant regulator in the housing
as shown.
b. Push against the spring force using assembly aid 9627 and turn until both sheetmetal edges are
touching the housing.
2. Install coolant
regulator
housing
c. Clean sealing
surfaces.
d. Position coolant regulator housing with a new
seal.
e. Tighten the three fastening screws
−arrow− .
Tightening torque: 10 Nm (7.5 ftlb.)
3. Push on coolant hose.
f. Insert retaining
clip.
g. Push the coolant hose with a new seal into the coolant regulator
housing.
h. Push hose downwards until the retaining clip is heard to
engage.
i. Pull the hose slightly to check for secure
seating.
Installation overview of the coolant regulator
einordnung
2035