Replacing Rear Spoiler Fork - Porsche 996 TT Repair Manual

No. Procedure
Unscrew the
fastening screws
−3− fully
Open the rear lid
1 Fit the rear spoiler
−5− on to the rear
lid
2 Fit fastening screws
−3−
1 Install covering
frame −2−

Replacing rear spoiler fork

1. Removing and installing rear spoiler fork
a. Unscrew the fastening screws −1− from the rear spoiler fork −2− and the rear
spoiler −3− .
b. Replace rear
spoiler fork
Note
• During installation, the fastening screws −1− must always be secured with Loctite 240 −inset− .
c. Position the rear spoiler fork −2− on the rear spoiler −3− . Secure the rear spoiler fork −2− with the
fastening screws −1− . Tightening torque: 10 Nm (7.5 ftlb.)
Replacing rear spoiler fork
Instructions
To simplify the installation of the rear spoiler, the fastening screw −3− and
the clamping piece −4− should be unscrewed fully.
Only install the rear spoiler with the rear lid open.
1. Place the rear spoiler −5− on to the rear lid. Ensure that the pegs −A− of
the rear spoiler fork are guided into the bracket −7− .
2. Tilt the rear spoiler und and down several times. Make sure that the rear
spoiler fork −6− is guided into the bracket −7− free of tension. If
necessary, shift the bracket −7− ' 55 Disassembling and assembling rear
lid
3. Tighten the fastening screws −3− and the clamping piece −4− .
Tightening torque: 23 (17)
Position the clamping piece −4− and tighten the clamping piece with the
fastening screw −3− .
Tightening torque: 10 Nm (7.5 ftlb.)
Guide covering frame −2− in. Screw in fastening screw −1− .
einordnung
1982