Porsche 996 TT Repair Manual page 2053

No. Procedure
6 Install right section (A−pillar
support) −A−
7 Install right section −A− on
the base cage −C−
8 Install left section (A−pillar
support) −B−
9 Install left section −B− on the
base cage −C−
Installing the roll−over bar
einordnung
Instructions
Guide the right section (A−pillar support) −A− inwards from the
right door. Position on the fastening plate on the vehicle floor and
screw into place with the washers −6− and the fastening screws
−5− .
Tightening torque: 23 Nm (17 ftlb.)
Screw into place on the screwed points of the base cage −C− with
the fastening screws −3− .
Tightening torque: 23 Nm (17 ftlb.)
Guide the left section (A−pillar support) −B− inwards from the left
door.
Position on the fastening plate on the vehicle floor and screw into
place with the washers −6− and the fastening screws −5− .
Tightening torque: 23 Nm (17 ftlb.)
Screw into place on the screwed points of the base cage −C− with
the fastening screws −3− .
1990