Tightening Torques - Porsche 996 TT Repair Manual

20. Heat cylindrical−roller bearing (no. 1 in overview) to 120°C and push onto output shaft.
21. Heat cylindrical−roller bearing (no. 32 in overview) to 120°C and push onto input shaft.
22. Fit oil tube (no. 22 in overview). Use new micro−encapsulated screw.
Tightening torque: 6 Nm (4.5 ftlb.)
23. Fit shift rods, selector shaft and locking elements. Affix locking elements with viscous grease if
necessary. Ensure that that the rollers on the selector shaft are complete.
1 Shift rod for 3rd/4th gear
2 Locking element (short)
3 Shift rod for 5th/6th gear
4 Intermediate lock
5 Locking element (long)
6 Reverse gear shift rod
7 Intermediate lock
8 Locking element (short)
9 Shift rod for 1st/2nd gear
24. Fit locking elements (no. 33, 34 and 35 in overview).
Note
Do not move the shift rods past the neutral lock or gear lock during or after fitting as otherwise the
•
small locking elements and the balls of the lock can fall into the transmission.

Tightening torques

Location
Tensioning plate on transmission case
Oil pipe on tensioning plate
Tightening torques
einordnung
Thread Tightening torque Nm (ftlb.)
M 8
M 5
25
6
1947