Porsche 996 TT Repair Manual page 2052

No. Procedure
1 Install right spring dome
support section −D−
2 Install left spring dome
support section −E−
3 Install base cage on right
of vehicle floor
4 Install base cage −C− on
left of vehicle floor
5 Install the base cage −C−
and selector sleeves −9−
Installing the roll−over bar
einordnung
Instructions
Position the spring dome support section −D− in the rear of the
passenger compartment onto the spring strut mount on the right.
Tighten in place with the fastening nuts −7− .
The fastening nut −7− must always be replaced.
Tightening torque: 46 Nm (34 ftlb.)
Carry out a test drive after performing assembly work on the
roll−over bar/spring strut mount threaded parts on the body and
then re−tighten the fastening nuts (three per side) to the torque: 46
Nm (34 ftlb.).
Position the spring dome support section −E− in the rear of the
passenger compartment onto the spring strut mount on the left.
Tighten in place with the fastening nuts −7− .
The fastening nut −7− must always be replaced.
Tightening torque: 46 Nm (34 ftlb.)
Carry out a test drive after performing assembly work on the
roll−over bar/spring strut mount threaded parts on the body and
then re−tighten the fastening nuts (three per side) to the torque: 46
Nm (34 ftlb.).
Position the base cage −C− on the fastening plate. Install the
washers −6− and the fastening nuts −5− . Tightening torque: 23
Nm (17 ftlb.)
Position the base cage −C− on the fastening plate. Install the
washers −6− and the fastening nuts −5− . Tightening torque: 23
Nm (17 ftlb.)
Push selector sleeves −9− onto the spring dome support sections
on the left and right −D, E− . Position the base cage −C− onto the
sections of the spring dome support −A, B− . Push the selector
sleeves upwards over the connector tube of the base cage.
Screw the hole pattern of the selector sleeves on the hole pattern of
the base cage −C− and of the spring dome support sections −D, E−
. Install the fastening screws −8− and tighten with the fastening
nuts −5− . Tightening torque: 16 Nm (12 ftlb.)
1989