Teaching Display And Operator Control Unit (Pcm 2) - Porsche 996 TT Repair Manual

9. Connect the electrical plug connections to the switch cover.
10. Position switch cover and press in until it is felt to engage.
Note
• After installation of a new display and operator control unit, the system must be activated with the
Porsche System Tester!
11. Connect and switch on the Porsche System Tester 2.
top of page

Teaching display and operator control unit (PCM 2)

Note
• If a new PCM is to be installed in a vehicle, the PCM2/CDR23 code specified in IPAS must be used.
• You can get the codes from IPAS or from your importer by specifying the vehicle identification
number.
• During coding, the power supply for the Porsche System Tester should be guaranteed. Connect a
battery charging device to the vehicle battery.
• Symbol for the TAB key = '|
• The Porsche System Tester instructions take precedence and in the event of a discrepancy these are
the instructions that must be followed. A discrepancy may arise with later software versions (from
20.0).
• The procedure described here has been structured generally; different text or additions may appear in
the Porsche System Tester.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on ignition. Press
>> to continue.
2. Select vehicle type using the cursor keys.
3. Using the >> key, move from the vehicle type to the list of control modules.
4. Select PCM2 with the cursor keys and press the >> key.
5. In the PCM2 menu, move to PCM2 MMI using the cursor keys and press the >>
key.
Teaching display and operator control unit (PCM 2)
einordnung
1717