3. Apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
4. Fit the brake disc.
5. Adjust the parking brake shoes and parking brake cables.
Note
•
Replace the brake caliper fastening screws after each removal!
The brake caliper fastening screws for PCCB brake discs are 8 mm longer (85 mm) than on cast iron
•
brake discs (77 mm)!
6. Fit brake caliper with new fastening screws. Tightening torque of the fastening screws = 85 Nm (63 ftlb.).
7. Mount wheel. For a wheel installation, 2 assembly aids (assembly pins) must be screwed into the
wheel hub.
Note on bedding in the new brake pads
New brake pads require a slightly longer bedding−in period for PCCB brake discs than cast iron brake discs.
In general, the following applies: New brake pads must be worn in (bedding−in period), their optimum
braking effect is therefore not reached until after a few hundred kilometers. The slightly reduced braking
effect must be compensated for by increased pressure on the brake pedal. The same also applies after a brake
disc change.
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
Installation
einordnung
1928