Tools - Porsche 996 TT Repair Manual

13. Lay the red/brown lead −C− from the service wiring harness to the plug (black) of the alarm system
control module, crimp the lead to the red/brown lead, pin B8 − wiring diagram, external loads, terminal
30 − and insulate the lead. The leads must be watertight. => Tools
14. Insert the plug for the alarm control module and fit the control module to the floorpan.
15. Engage the tilt sensor on the tilt sensor bracket.
16. Insert the service lead plug into the tilt sensor.
17. Fit the parking assistant control module to the new cover −1− with the fastening screws and insert
both plugs into the control module. Pay attention to the new installation position.
18. Insert the tilt sensor −3− into the cover −1− and screw the cover tight to the floorpan using the
fastening screws −arrow− .
19. Lay the lead under the cover, making sure that no electrical lead can be caught when the seat is operated.
20. Install the seat ' 720119 Removing and installing front seat.
21. Make sure the system is functioning properly with the Porsche System Tester.
top of page

Tools

Item Designation of the special tool
1 Repair set for wiring harness
155−1
2 Press−out tool 155
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651, 996840, 996841
Tools
einordnung
Remarks
Workshop Equipment Manual, Gr. 2.4
Workshop Equipment Manual, Gr. 2.4
1767