Programming The New Dme Control Module 911 Turbo (996) - Porsche 996 TT Repair Manual

4. Turn over the control module holder −3− and push it in under the fastening nut −2− . Tighten both
fastening screws −1− and the fastening nut −2− . Tightening torque: 10 Nm (7.5 ftlb.).
5. Place carpet lining in position, paying attention to the fitted
shape.
6. Program the DME control module with the Porsche System Tester. => Programming the new DME
control module 911 Turbo (996) => Programming the new DME control module − GT2 and version X51
=> Programming the DME control module 911 Turbo (996) => Programming DME control module −
GT2 and version X51
top of page

Programming the new DME control module 911 Turbo (996)

Note
• If a new DME control module is to be installed in a vehicle, the DME code specified in IPAS and the
immobilizer code must be entered in the DME control module.
You can get the codes from IPAS or from your importer by specifying the vehicle identification
•
number.
• During DME programming, it is essential to guarantee the power supply for the Porsche System
Tester. In case of doubt, connect a charging unit to the vehicle battery.
• Symbol for the TAB key = '| .
• Follow the instructions for the Porsche System Tester.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
2. Select vehicle type using the cursor keys. In the 911 Turbo − 911 (996).
3. Using the '| key, move from the vehicle type to the list of control units.
4. Select DME with the cursor keys and press the >> key.
5. Select "Control unit programming" with the cursor keys and press the >> key.
6. Select "Control unit programming with the cursor keys and press the >> key. Follow the
displayed programming instructions from the Porsche System Tester.
7. Enter the Veh. Ident. No. with the cursor keys, continue with >> and confirm with F7.
8. Enter the new DME (IPAS) programming code and confirm with the >> key.
9. Check the DME programming code again; if the code is correct, confirm with the F7 key.
10.
Installing the DME control module
einordnung
1207