Porsche 996 TT Repair Manual page 1779

3. With the PCM removed, carefully lever out the navigation module using a screwdriver.
4. Insert the navigation module into the PCM to be installed.
5. Position the cover and press into place.
6. Push on the electrical plug connections for the display and operator control unit in the sequence −D, B,
A− and the antenna plugs −A, E and F− until they are felt to engage.
7. Check that the locking tabs on the PCM are out −arrow− , opening the lock with a
hexagon−socket wrench if necessary.
Note
• Before sliding the PCM into the installation slot, make sure that the electrical leads are not trapped by
the PCM or damaged.
8. Push the navigation unit into the installation slot until the locks engage on the PCM
housing.
Installing display and operator control unit (PCM 2)
einordnung
1716