1. Push coil spring −6− , spring plate −3− with rubber ring −4− and bellows −5− onto the vibration damper.
The tighter winding of the coil spring −6− must face down towards the damper tube −7− .
Note
•
The coil spring is fitted with a protective sheath on one side!
2. Grease thread of the piston rod with Optimoly HT (copper grease/only at the front
axle).
3. Push the assembly of the spring strut mount −2− (consisting of Parts No. 8/ No. 9 / No. 10 / No. 11)
onto the piston rod.
Note
•
The mounts for the right and left sides are identical parts!
•
In the case of used mounts, the bearing shell can be regreased with Autol Top 2000! Manufacturer:
Autol−Werke, Paradiesstr. 14, D−97080 Würzburg.
Replace nut for fastening the piston rod on the spring strut mount!
•
•
Never use an impact bolter to tighten the fastening nut!
Assembly
einordnung
1841