Porsche 996 TT Repair Manual page 1438

No. Procedure
1 Cleaning the welding areas
2 Cleaning welding and sealing
areas
Coat single point flange areas
with zinc−rich varnish.
3 Reinforcement spot welding Spot−weld the reinforcement −X− and the side member with six
4 Inserting the side member
into the body
Preparing and fitting the front inner side member for installation
einordnung
Instructions
Remove the factory−applied primer on the welding areas of the
spare parts −A, B, C, D, E, F, G, X− using the rotary brush.
Drill or punch (with a hole punch) 7 mm holes spaced 20mm apart
for plug−welding with shielding gas.
=> Welding in front inner side member
Remove underbody coating and paint layers, etc. from the welding
areas of the body with the hot−air gun or rotary brush.
All single point flange areas which will not receive a body adhesive
application should be coated with a zinc−rich varnish −A, B, C, D,
E, F, G, X− .
spotwelds.
Straightening attachment −arrow− for front−axle mount or on the
impact pipe (impact absorber) −arrow− must be screwed on for the
1375