21 Transmission
1
housing
Note
* Parts of the shifting mechanism will fall into the transmission if the bearing screw No. 23 is
•
unscrewed.
top of page
Disassembly and assembly instructions
Disassembly
1. Remove closure cap. To do this, drill a 3.5 mm hole into the centre of the cap, screw in a
sheetmetal screw (4.8 x 25) with large washer, and lever the cap out using two screwdrivers.
Assembly
1. Fit selector lever and shift pinion in the correct position. (The driver cross is vertical and the selector lever
reaches the flat surface of the housing.)
Disassembly and assembly instructions
einordnung
1867