Installation - Porsche 996 TT Repair Manual

Installation

WARNING
Danger of accident if old parts are fitted on brake caliper!
• Fit new expanding spring and new retaining pin with a new screw on the brake caliper!
Note
• Ensure correct brake pad quality! Use brake pads as per Spare Parts Catalogue!
• The pad backing plates (rear side of the brake pads) must not be greased!
• For a wheel installation, 2 assembly aids (assembly pins) must be screwed into the wheel hub!
1. Before installation of the brake pads, check the wear of the brake discs => Checking front PCCB brake
discs (wear assessment).
2. If necessary, press back the piston to its original position using the resetting fixture.
3. Fit new damper plates in the pistons. As the vibration dampers are provided with a protective film, the
protective film must be removed before installation.
4. When fitting the vibration dampers on the small pistons, the cut−out on the vibration damper −arrow− is
to be positioned at the brake pads guide pins as otherwise the vibration damper will be deformed!
5. Insert the brake pads.
Installation
einordnung
1917