Tightening torques
Location
Hexagon nut (no. 1 in overview)
top of page
Assembling input shaft
Assembling shaft
Note
•
The overview diagram of the output shaft is provided in the chapter disassembling transmission under
Disassembling output shaft .
1. Heat cylindrical−roller bearing (no. 6 in overview) to 120°C and push onto
output shaft.
2. Heat bearing inner race (no. 5 in overview) to 120°C and push onto output shaft.
3. Push on four−point bearing (no. 4 in overview) onto output shaft.
4. Heat bearing inner race (no. 3 in overview) to 120°C and push onto output shaft.
top of page
Installing input and output shaft
Installing shafts
Note
•
An overview diagram of the installation is provided in the chapter 'disassembling transmission' under
Removing input and output shaft .
Tightening torques
einordnung
Thread
Tightening torque Nm (ftlb.)
M30 x 1.5
250
1944