Porsche 996 TT Repair Manual page 2083

No. Procedure
1 Sticking on model logo
2 Installing air guide
3 Fitting fan with fan housing Position fan with fan housing −24− , screw down with fastening
4 Fitting upper part of the
lock
5 Installing adjusting element Engage collar −20− . Screw in rubber pads −19− .
6 Fitting rubber covering
Assembling rear lid
einordnung
Instructions
=> Replacing the model logo
Position the air guide −25− on the rear cover and insert.
screws −23− .
=> Tightening torques
Connect plugs for fan and engine compartment lighting on the
fan housing.
See: => Removing and installing wiring harness
Position upper part of the lock −22− and fasten with fastening
screws −21− .
=> Tightening torques
Position the rubber covering −18− on the rear cover and push in.
=> Installing rubber covering − Cabriolet
2020