Porsche 996 TT Repair Manual page 2084

Installing wiring harness
7 Fitting mount
No. Procedure
8 Fitting hinge
9 Mounting the lower part of
the spoiler
Assembling rear lid
einordnung
=> Removing and installing wiring harness
Position the mount −17− on the rear cover and screw in using
the fastening screws −15− and −16− .
=> Tightening torques
Instructions
Position hinge −11− and screw in using the fastening screws −14− .
=> Tightening torques
1. Position the spacer −13− on the lower part of the spoiler. Tighten
the fastening screws −12− .
2. Position the upper part of the spoiler on the hinge −11− . Using
the threaded plate −10− and the fastening nuts −9− securely
screw down the upper part of the spoiler.
=> Tightening torques
2021