Assembling Rear Lid - Porsche 996 TT Repair Manual

No. Procedure
6 Removing the mount
7 Removing rubber covering Pull rubber cover −18− out of the rear cover.
8 Removing adjusting
element
9 Removing upper part of
the lock
10 Removing fan with fan
housing
11 Removing air guide
12 Removing model logo
Removing reflector cover => Removing and installing reflector cover
top of page

Assembling rear lid

Assembling rear lid
einordnung
Instructions
Unscrew fastening screws −15− and −16− from the actuating element
−17− .
Unscrew rubber pad −19− and unclip collar −20− .
Unscrew fastening screws −21− and remove upper part of lock −22− .
Disconnect plug connections for fan and engine compartment lighting
on the fan housing.
See: => Removing and installing wiring harness
Unscrew fastening screws −23− and remove fan with fan housing
−24− .
Pull off air guide −25− from the rear cover.
Pull off model logo −26− .
2019