C
Retaining device
D
Socket wrench insert
E
Pressure piece
F
Two−armed extractor, span 250 Commercially available; refer to Workshop Equipment
G
Separator 17 − 75 cm
H
Two−armed extractor, span 120 Commercially available; refer to Workshop Equipment
J
Puller hook, 400 mm long
top of page
Removing transmission cover
1. Remove transmission ' 34 35 27 Removing and refitting the
transmission.
2. Fasten the transmission on assembly support.
3. Drain transmission oil ' 34 01 55 Changing transmission oil.
4. Fix the transmission with special tool retaining device 9253 and shift into a gear.
5. Unscrew the fastening nut for the cardan shaft flange with a commercially available socket wrench
insert Workshop Equipment Manual, Chapter 2.4, No. 64 .
6. If necessary force cardan shaft flange off with a rubber hammer.
7. Unscrew fastening screws for front transmission case cover and force transmission case cover off
with a rubber hammer if necessary.
top of page
Disassembling front gear set
Overview
Tools
einordnung
Special tool retaining device 9253
Special tool socket wrench insert 9282
Special toolpressure piece 9656
Manual, Chapter 2.4, No. 103
Commercially available; refer to Workshop Equipment
Manual, Chapter 2.4, No. 109
Manual, Chapter 2.4, No. 101
Commercially available; refer to Workshop Equipment
Manual, Chapter 2.4, No. 105
1217