Assembly - Porsche 996 TT Repair Manual

• The stabilizer mating bearing (mounting saddle) −4− need not be adjusted for street use.
• The hook wrench insert Sonderwerkzeug 9647 is required to change the vehicle height and to adjust
the stabilizer mating bearing on the front and rear axle. The special tool is used together with a torque
wrench to tighten the lock nuts (slotted nuts) on the spring struts.

Assembly

1. Slide the additional spring −9− , washer −8− and stop plate −7− (stop plate in correct position) as far as
they will go on the piston rod.
2. Place coil spring −6− in the correct position, tighter winding facing down, onto the vibration damper.
Note
Preliminary work and notes on assembly
einordnung
1847