Porsche 996 TT Repair Manual page 2055

No. Designation
1 Rear cover −1−
2 Flaps in the floor
covering −2−
A Closure caps −3−
1)
Only after removal of the roll−over bar
2)
Only during installation of the roll−over bar
Assembly instructions for the rear trim, the floor covering andthe closure caps
einordnung
Qty. Removal
1 Lift the rear cover −1− up and out.
4 Pull out the flaps in the floor
covering −2− .
4 In order to install the roll−over bar,
the closure caps −3− should be
removed from the floor covering,
2)
inset −2−
996840, 996841
Installation
Press the rear cover −1− in
between the side−panel
lining and the roll−over bar
2)
−D, E− .
In vehicles where the
roll−over bar has been
removed, the rear cover may
be replaced if necessary (for
reasons of appearance).
Press in the flaps in the floor
covering −2− around the
roll−over bar −A, B, C− .
After the roll−over bar has
been removed, the flaps in
the floor covering should be
closed with the closure caps
1)
−3− .
1)
1992