5. Remove adhesive tape through the assembly opening in the release
fork.
6. Fit bearing cover with special tool removal mandrel 9287 .
7. Fit holder for clutch control shaft.
Tightening torque: 10 Nm (7.5 ftlb.)
8. Refit transmission on motor and screw in screws.
Tightening torque: 45 Nm (33 ftlb.)
9. Fit air flanges.
Tightening torque: 10 Nm (7.5 ftlb.)
10. Engage starter cable and push vacuum line onto coolant valve.
11. Install engine−transmission unit. ' 100119 .
top of page
Tightening torques
Location
Transmission on engine
Air flanges on transmission
Bracket for clutch control shaft on transmission
Tightening torques
einordnung
Thread
M10
M6
M6 x 16
996840, 996841
Tightening torque Nm (ftlb.)
65 Nm (48 ftlb.)
10 (7.5 ftlb.)
10 (7.5 ftlb.)
1863