Removing And Installing Additional Brake Light - Porsche 996 TT Repair Manual

10 Mounting the folding wall
on the cover
11 Mounting the the folding
wall on the upper part of the
spoiler
12 Mounting the upper part of
the spoiler
top of page

Removing and installing additional brake light

1. Removing additional brake light
a. Unclip cover −A− at the sides, unlock lock −B− . Remove brake light and disconnect plug connection
−C− .
Removing and installing additional brake light
einordnung
3. Position the fastening rail −8− on the folding wall −6− and the
rear cover.
4. Put new clamping washers −7− on the pegs of the fastening rail.
5. Insert the rail −5− with the folding wall into the lower part
of the spoiler in −direction of arrow− .
6. Press in the expanding rivets −4− .
7. Adjust the clamping screws to dimension −X = 8
mm− .
8. Place the upper part of the spoiler −3− on the lower part of the
spoiler. Ensure that the locking tabs −inset V− have engaged.
9. Screw down the clamping screws −2− .
=> Tightening torques
Push in the plastic plugs −1− .
2022