Table of Contents
Advertisement
2.2.6
fader Bay Details
2.2.6.1
Channel Control
Rotary Control
2.2.6.1.1
Activating Two-Layer Mode
Document generated: 18.04.17
If an analog Studer Mic/Line preamp (either built-in or in a Studer Compact
Stage Box) is connected, the analog gain will be controlled before the A/D
converters. If not, the rotary control will adjust digital input gain. In any case,
further control is available on the Vistonics module. Control of a Studer mic/
line preamp is indicated by a small red MIC LED at the bottom of the rotary
control.
IN1, IN2
Input Selector. Each channel has three patch points available (the channel
patch is visible on the Graphical Controller screen,
patched to the internal generator's output by default, but can be changed by
the user at any time. Only In1 and In2 can be switched directly from within
each channel strip. In order to activate In3 (Generator), the user must click
on the input switch area of the Channel View window within the Graphical
Controller screen, as shown below.
↓ L2 ↓
(Layer 2 switch) If two-layer mode is enabled, this key switches to view the
lower layer of the two.
SW V5.3
Vista 1 Digital Mixing System
By activating 'Enabled on Faderbays...' in the Option
- Vista Settings menu, the virtual desk may be reduced
from six to three sections. The previous sections 4...6
now serve as a second (lower) layer of the console.
By pressing the ↓L2↓ key on the channel strips, one indi-
vidual channel strip can be switched between the upper
and the lower half of the console. If a channel strip is
currently displaying the third channel of section 1, it will
afterwards display the third channel of section 4. This
function may be helpful when working e.g. with backup
microphones. In this way it is easy to switch to a different
channel while leaving the other ones untouched.
chapter
4.4.3). Input 3 is
Click here
Desk Operation 2-53
Advertisement
Chapters
Table of Contents
