Studer Vista 1 Operating Instructions Manual page 51

13
25
Solder/Crimp View
(or Socket View)
2.1.4.2 front Connectors
DATA USB Socket
Jingle Player USB Socket
Headphones Socket
Document generated: 18.04.17
GPO 1-8 (25-pin D-type, female, UNC 4-40 thread)
Signal 'GPO 1-8'
Pin
1 GPO 1a
2 GPO 2a
1
3 GPO 3a
4 GPO 4a
5 GPO 5a
14
6 GPO 6a
7 GPO 7a
8 GPO 8a
9-13 GND (0 V)
In the SYSTEM Area of the control bay; for data backup and restore purposes
or, e.g., connecting a USB keyboard.
Under the desk's hand rest at the right-hand side; reserved for the integrated
jingle player only. This USB socket may, of course, also be used for an
external hard drive. If this drive takes its power supply from the USB socket,
its consumption must not exceed 500 mA. Supplying the unit externally is
strongly recommended.
A USB memory device MUST NOT BE UNPLUGGED DURING DATA
!
ACCESS – only remove it after its LED has stopped flashing in order to
avoid data loss!
Under the desk's hand rest at the right-hand side; this is a standard 6.35 mm
TRS headphones socket. Recommended headphones impedance 75 - 300 W.
Headphones with higher and lower impedances may be used but will produce
reduced listening level.
Pin Signal
Sleeve Ring Tip
Tip Left Channel
Ring Right Channel
Sleeve Screen/GND
SW V5.3
Vista 1 Digital Mixing System
Pin Signal 'GPO 1-8'
14 GPO 1b
15 GPO 2b
16 GPO 3b
17 GPO 4b
18 GPO 5b
19 GPO 6b
20 GPO 7b
21 GPO 8b
22-25 VCC (+5 V / 600 mA max.)
Desk Operation 2-11