Table of Contents
Advertisement
4.7.3
Setings: Meter Source Setup
1
2
3
GROUP
GROUP
GROUP
GROUP
1
2
1
5
6
7
MAIN
MAIN
EXT
1
2
1
Document generated: 18.04.17
The master level meter assignment is preconfigured using the Graphical
Controller. Selection of these preconfigured sources will then be done with
the eight hardware METER keys below the meter window; these keys have
clip-on caps for inserting individual labels mirroring the individual setting.
The METER key numbering 1-8 is shown left.
In order to change metering sources, the operator needs to be logged-on as a
system administrator. This is done in the Settings Ribbon Tab, category Setup.
The Meter Source button needs to be pressed.
4
2
8
EXT
2
The Meter Source Setup window opens up and displays all necessary param-
eters to assign metering sources to the six VFD bargraph meters. The steps
below describe the setup process :
The desired METER source selection key is selected with a click.
Step 1
Step 2
In the pulldown menu at the right-hand side all sources assignable to the
meters are shown.
Click to select the source, then click on the << arrow button of the desired
bargraph. Please note that here the numbering is 1 through 6 from top to
bottom, while on the actual desk meters it is 1 through 6 from left to right.
Step 3
Once this is done for all 6 meters, proceed to the next source selection key
SW V5.3
Vista 1 Digital Mixing System
GC Operation 4-135
Advertisement
Chapters
Table of Contents
