Studer Vista 1 Operating Instructions Manual page 289

Vista 1 Digital Mixing System
The chosen Bus Owner channel is shown in the list as (in our example,
Outside Line 1), any assigned channels to the bus are shown in the list as
(e.g. Inp m 56).
Clicking on individual channel boxes will either select or deselect a channel;
this makes the N–1 bus in fact being an N–x bus. It is also possible to mark
a number of channels to be assigned by left-clicking and dragging across a
number of channels for speed.
It is also possible to assign channels to a configured N–1 bus by using the
bus assign window on the control surface.
The talkback and N–1 bus level control will be displayed in the assigned
channel strip for the N–1 Bus Owner Channel.
 Tip The N–1 settings are saved within snapshots.
Option to bring back ALT N–X status upon closing fader
Option active ( ) : The signal will switch back to ALT N–X upon closing the

fader again, in case it was active before opening. This allows e.g. feeding an
off-air signal to the outside lines while they are not on air (e.g. output signal
from on-air console including commercials).
Result: When the fader is opened, the outside lines get the normal N–X signal;
when closed they are switched to the off-air signal.
GC Operation 4-113
Document generated: 18.04.17 SW V5.3