Vista Settings - Studer Vista 1 Operating Instructions Manual

7.2

Vista Settings

Machine Control Window
Transport Control Enable
MIDI-Over-Ethernet:
Document generated: 18.04.17
In case the Timecode/Generator/Machine Control icon should not be shown
in the GC, proceed as follows:
• Open the C:\D950System\D950system.ini file.
• Under [options], edit the two lines shown in bold print below:
[options]
TC2=No
TC3=No
InternalTC=Yes
MeterOverNet=No
DynamicAutomation=No
StaticAutomation=Yes
MidiActive=Yes
TheatreMode=No
To enable transport control specifically for the connected DAW, there is a
menu option in the TC Reader / Generator setup dialog. Please note that
the 9-pin serial control is disabled as soon as the DAW Control setting is
selected:
Instead of the MIDI connection normally used as the physical layer for the
Mackie protocols, a MIDI-over-Ethernet solution is used that allows using
one single Ethernet Cat5 cable instead of several MIDI cables. Therefore the
'ipMIDI' driver needs to be installed on both the Vista desk PC and on the
DAW.
SW V5.3
Vista 1 Digital Mixing System
DAW Control 7-5