Table of Contents
Advertisement
4.4.2.1
General Patch navigation
4.4.2.1.1
Navigating the Sources/Targets List
Document generated: 18.04.17
The audio sources list (located on the Y axis) and the targets list (on the X
axis) allow the user to find and select a Source/Target pair, and to make or
clear a required cross-point connection.
There are different ways to navigate and select the required source and target
for making or clearing patch connections. The simplest process to select the
required Source/Target selection is described below:
1
Select the Patch Group of the required source/target using the Source- and
Target Patch Group selector. This will show in the X-Y axis list all the pos-
sible sources/targets available in the configuration currently loaded. Scrolling
using the standard windows scroll bar may be required to see all the sources/
targets from the chosen Patch Group. Select the required Source/Target by
clicking on the Source/Target name or by using the keyboard cursor arrows
to move up and down the list. This will position the Selection bars of the
X-Y axis to the chosen Source/Target. The intersection of the two Selection
bars will allow the making or clearing of a cross-point based on the chosen
Source and Target
(see chapter 4.4.2.4
clear cross-point connections).
Select the source
Select the target
2
Select the required Page Patch Group in the Page Patch Group selector. This
will show the X- and Y axis of the predefined Patch Group at once. Proceed
as described above to select source and target.
SW V5.3
Vista 1 Digital Mixing System
for information on how to make or
GC Operation 4-15
Advertisement
Chapters
Table of Contents
