Channels, Routing And Busses - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
1.3

Channels, Routing and Busses

Input Ports
16-Ch Input
Input Mono 1...n
Modules
D21m
Option Slots
USB
Jingle Player
Input Channels
Output Channels
Auxiliary Busses (AUX)
Clean-Feeds/Mix-Minus (N–X)
Multi-track and Group Routing
Solo Modes
1-18 Introduction
Input Channels
EQ INS DYN DLY
Gain
CH Switching Matrix
HP/LP
Phase
Configurable Processing
AF
PF
INP
Input Stereo
1...n
Input 5.1
1...n
Processing blocks, such as equalizer, dynamics, delay, etc., can be configured
for all channel types.
Vista's digital routing matrix is located between the console's physical inputs
and the actual DSP channels. This topology means that the physical analog
and digital inputs can be assigned to any console channel via the General
Patch page on the Graphical Controller. The patch setup forms part of each
individual snapshot, and can be saved, updated and recalled within the Snap-
shot/Preset system.
This also applies to the outputs. On the General Patch page, each channel's
output can be selected and sent to any analog or digital output destination.
The number of stereo or mono AUX sends is pre-defined by the configuration
currently loaded – four configurations are shipped with the console to select
from. The AUX master channels are equipped with a selection of processing
blocks such as equalizer, dynamics, delay, and more (or less).
Mono or stereo clean-feeds/mix-minus busses (also referred to as 'N–X') are
also part of the configuration currently loaded.
Multi-track and group routing is part of the currently selected configuration,
as already mentioned above.
Each channel features a Solo and a PFL Switch. Depending upon the mode
selected within the control bay the SOLO key is active as SOLO or Solo-In-
Place. Clearing these buttons can be achieved by opening the corresponding
fader in case 'PFL BC' (Broadcast) is active. A very handy PFL/Solo Reset
is provided to disengage any solos regardless of where they are engaged on
the console. This eliminates the need to 'search' for solos with large console
configurations. A key to define certain channels to be safe from being muted
in 'Solo-In-Place' mode is also provided. This set will be stored with each
title.
SW V5.3
Buses
Fader
L/R or
Mute
Surround
PAN
Master, Group,
PFL, SOLO,
MCH, N–1
Direct Out
6
DSP Router
Output Channels Output Ports
AUX Mono 16-Ch Output
1...n
AUX Stereo
1...n Option Slots
GRP Mono
1...n
GRP Stereo
1...n
GRP 5.1
1...n
Master Mono
1...n
Master Stereo
1...n
Master 5.1
1...n
Document generated: 18.04.17
Modules
D21m