Studer Vista 1 Operating Instructions Manual page 328

Vista 1 Digital Mixing System
4.8 Fifth level: The Surveyor
The Surveyor Icon/Button:
4-152 GC Operation
Vista constantly monitors the status of all major hardware and software sys-
tems. This information is provided to the user via the Surveyor. The Surveyor
is also the primary diagnostic tool used for troubleshooting and fault finding.
The Surveyor displays its information in two ways:
• The Icon/Button shown on the left hand side of the Ribbon menu bar;
• The Surveyor page.
The Surveyor Icon/Application Menu Button is always located in the Ribbon
menu bar. It is intended to keep the operator informed about general system
status. The icon changes to indicate the overall condition of the Vista. These
indications are as follows:
Grey circle: The system is starting up.
Green circle: The system is working and OK.
Green circle with yellow exclamation mark: Not Found. A system element
cannot be found. This is sometimes seen while a configuration is loading. If
this icon remains on, a problem is indicated
Red circle: Error. An error, fault, or failure is detected in the system. If this
icon remains on, a problem is indicated..
SW V5.3 Document generated: 18.04.17