Snapshot Crossfading - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
4.4.4.3

Snapshot Crossfading

4-44 GC Operation
In the Theatre CueList, it is possible to define a crossfade time for each cue
- and therefore a crossfade time can be applied to a snapshot. This is done by
simply clicking on the crossfade time and scroll your touch pad up or down.
If the crossfade feature is deactivated (see
to adjust the crossfade time.
The snapshot crossfading may be deactivated by deselecting the Xfade Active
option on the Theatre CueList.
Settings that cannot be crossfaded (switches) can either switch at the begin-
ning, in the middle of the crossfade or after the crossfade. This behavior can
be defined in the Snapshot Automation Options window selected from the
Ribbon tab Snapshot, category Options. There, it is also possible to define
a Default Crossfade Time.
For an explanation of the Enable Trim Mode option, refer to
SW V5.3
chapter 4.4.5.2.1), it is impossible
chapter 4.4.4.7.
Document generated: 18.04.17