Output Patching - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
8.2

output Patching

8-4 RELINK
Shared inputs can be selected directly from any of the displayed systems.
The sources of OnAir consoles – e.g. a DJ microphone – are appearing as
'Logical Inputs', and their output signals as 'Master Outputs'. Please note
that the names of the connected systems are only shown when the whole tab
is unfolded. Right after the name of the system, two numbers are displayed
which inform about the amount of connections to this system.
The first number is the amount of still available mono audio channels com-
ming from this system. The second number is the amount of configured mono
audio channels comming from this system.
To get to the outputs of the connected RELINK-systems, the targets-tab has
to be unfolded, so that the system names are displayed. Here, also the number
of still available audio channels - and the number of totally configured audio
channels to this system are listed.
'Set Outputs' activates all preselected patch points to outputs on remote
systems. This introduces an additional safety step in creating a remote patch
connection.
The operator might want to switch several outputs to a different system (e.g.
program outputs) at the same time. So when he is making the connections
in the patch, they are marked in gray, indicating that the connection has not
yet been established. Only when the 'Set Outputs' button is clicked, all the
gray connections are set active at the same time. 'Set Outputs' only becomes
active if some output patch connections are made to other systems.
This is only necessary when doing patch connections manually. When using
snapshots, the connections are applied immediately.
SW V5.3 Document generated: 14.04.17