Table of Contents
Advertisement
Vista 1 Digital Mixing System
3.3.14
Generic and Label Display Area
3-24 Parameters
Channel label display: The top line always indicates the inherited label (corre-
sponds to the device label of the patched source) of each channel. The second
line normally is set to device label display, but can be changed by pressing
GLOBAL VIEW: LABEL TYPE.
The channel type is indicated with colors in the label display; in addition, the
bottom right corner of the label field shows the channel type in writing, as
shown below.
Generic Displays, such as n–1, OVER (fader over-range), etc. are only shown
as long as they are active:
The numerical fader value is displayed in dB whenever the fader knob is
touched; it disappears a short while after the fader knob has been released.
The graphical display of snapshot preview value and current fader value pops
up over the right-hand part of the display area, showing the values as bar
graphs (current value in gray, snapshot preview value in pink).
Channels that feed a VistaMix (VMX) bus will show one (mono VMX) or
two (stereo VMX) minature fader symbols in the label area of the Vistonics
display that show the gain of the Vistamix function dynamically. Please note
that these are not audio level meters.
SW V5.3
Document generated: 18.04.17
Advertisement
Chapters
Table of Contents
