How To Use The Strip Setup; Assigning A Single Dsp Channel To A Single Channel Strip; Assigning Multiple Channels In One Single Action - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
4.4.6.1

How to Use the Strip Setup

4.4.6.1.1

Assigning a Single DSP Channel to a Single Channel Strip

4.4.6.1.2

Assigning Multiple Channels in one Single Action

4-84 GC Operation
To create a new strip setup or to adapt an existing strip setup, first call up the
strip setup page (see above).
To assign a channel to one of the virtual channel strips, right-click on the
virtual channel strip that the DSP channel is to be displayed on. This will
highlight the chosen channel and a selection menu will appear, listing all
the categories of channel types. These are submenus that contain a list of the
available DSP channels in the currently loaded configuration. Move the cursor
to the drop-down menu of the desired channel type and select the desired
channel from the list to assign it to the highlighted channel strip.
It is possible to assign consecutive DSP channels onto consecutive channel
strips in one action. First use the hold and drag function of windows to select
a number of consecutive channel strips. This will highlight the selected chan-
nel strips. Right-click on any of the highlighted channels to open the channel
selector menus. Select the first channel of the consecutive channels to be
assigned. Consecutive DSP Channels will now be pasted to fill the number
of highlighted strips.
 Tip By double-clicking on a single channel, the complete bay of 10 strips that the
channel strip resides is selected. Three clicks on a single channel will select
all channel strips within the complete Section.
SW V5.3 Document generated: 18.04.17