Studer Vista 1 Operating Instructions Manual page 367

# The containerid identifies this container
# and must be unique within the mixing console system
# This id is fixed to ‹10› (CORE) for all VISTA desks
containerid = 20  ‚20' is always used when the container.ini belongs to a configuration tool
# The containername identifies this container in a readable way
# and must be unique within the mixing console system. It is recommended
# not to use more than 8 characters due to visualization aspects.
# «Undefined» is not allowed!
containername = «Config»
# Multicast
# -----------
# If you use IGMP multicasts instead of broadcasts in your network,
# you have to uncomment the lines below. It is possible that a
# container is member of one or more than one multicast groups.
#
# NOTE: For an optimal performance, make sure that all network resources
# (Switches, Routers...) support IGMP.
#
# NOTE: To avoid IP conflicts, check the available addresses for
# multicast groups (www.iana.org). Use preferable addresses from the
# local scope (239.255.0.0/16) described in RFC 2365.
#
# NOTE: If the multicast should reach computers beyond the local subnet
# Set MulticastTimeToLive > 1 (1 is default)
# MulticastGroup = 239.255.0.1
# MulticastGroup = 239.255.0.2
# MulticastGroup = 239.255.0.3
# MulticastTimeToLive = 10
# Multiple Network Adapters
# ---------------------------------
# When more than one network adapter is enabled on the computer, the MAC Address has to be specified
#
# MAC = 00-1A-A0-B9-F9-88
Document generated: 18.04.17
 the name of the container
With the exception of Vista 1, there needs to be a second container.ini file
Note:
on the Vista's control computer – the one that belongs to the mixing console
application.
SW V5.3
Vista 1 Digital Mixing System
RELINK 8-11