Pre-Amp Remote Parameters - Studer Vista 1 Operating Instructions Manual

Vista 1 Digital Mixing System
3.3.2

Pre-Amp Remote Parameters

MIC GaIn
hPF on/off
soFT CLIP on/oFF
48 V on/off
3-8 Parameters
Format
ITU
Studer (SW before V4.0)
Film
L R
Press GLOBAL VIEW: A / D CTRL.
Various analog functions of the mic/line input cards can be remote controlled.
On the 5.1 surround input channels these controls are linked for all six legs
of the surround signal. All mic/line cards provide an active split output for
each microphone channel.
Gain setting in steps of 1 dB, within a –26 through +60 dB range. The display
indicates the gain applied to signals passing through the microphone pre-
amplifier card. (indication value depending on the current 0dBFS Reference
setting).
Analog low-cut filter for the microphone-level input, with a fixed cutoff
frequency of 75 Hz and a slope of 12 dB/octave is available.
A soft clip function is available on all channels and can be activated individu-
ally. This 'analog limiter' may prevent nasty clipping noises in case the audio
level should be too high. We recommend activating this function during live
productions, since audio is not influenced below about –6 dB
Toggles phantom power on/off for the microphone input.
SW V5.3
Input Channels

L R C L F E Ls Rs
L R C Ls Rs LFE
L C R Ls Rs LFE
L R
Document generated: 18.04.17
ITU Output Channels
L R C LFE Ls Rs
.
FS